Page 4 of 4

Re: New project 3.0

PostPosted: Thu Dec 03, 2015 4:47 pm
by Eric David Bru
Are you going to be painting them or leaving them bare?

EDB

Re: New project 3.0

PostPosted: Thu Dec 03, 2015 8:24 pm
by danielb210
Eric David Bru wrote:Are you going to be painting them or leaving them bare?

EDB


I will clear them epoxy doesn't do well with UV. If the customer chooses to paint that is on them.

Re: New project 3.0

PostPosted: Tue Dec 15, 2015 8:37 pm
by danielb210
Between business trips it has been hard to get everything done. At any rate wings and canards are done just trying to finish the end plates. The loft grew a little beyond my estimates so I had to split the mounts. They are bonded and fastened on.

Re: New project 3.0

PostPosted: Tue Dec 15, 2015 9:20 pm
by admin
Looks great... That's 3K weave right?

Re: New project 3.0

PostPosted: Tue Dec 15, 2015 9:25 pm
by danielb210
6k 2 x 2

Re: New project 3.0

PostPosted: Wed Dec 16, 2015 12:42 am
by admin
VAVAVOOM! NICE!

Re: New project 3.0

PostPosted: Sat Feb 06, 2016 5:54 pm
by HardcoreAK
Hey Daniel,

I need to get something on the nose of my Bantam. I was planning to cut down / rebuild the fuel tank, and cover the front. Could you build a basic nose piece, and some canards?

Re: New project 3.0

PostPosted: Sun Feb 07, 2016 1:02 am
by danielb210
HardcoreAK wrote:Hey Daniel,

I need to get something on the nose of my Bantam. I was planning to cut down / rebuild the fuel tank, and cover the front. Could you build a basic nose piece, and some canards?


Cody, as short as the overhang on the car appears I think canards would be rough. I would suggest a one piece wing and be done. That said, as much as I need to get done on my car, for the moment I need to work on it. However, after I get it set for the season, I would be happy to help how I can.

Re: New project 3.0

PostPosted: Mon Feb 08, 2016 2:19 pm
by HardcoreAK
danielb210 wrote:
HardcoreAK wrote:Hey Daniel,

I need to get something on the nose of my Bantam. I was planning to cut down / rebuild the fuel tank, and cover the front. Could you build a basic nose piece, and some canards?


Cody, as short as the overhang on the car appears I think canards would be rough. I would suggest a one piece wing and be done. That said, as much as I need to get done on my car, for the moment I need to work on it. However, after I get it set for the season, I would be happy to help how I can.


This pic was the former owner, and his wild 565 combo... I'm running an injected small block this year so I can shake down the car and get it back to a decent set up, get me some seat time, so that sounds great! A one piece wing would be perfect...